Services
Services
The measurement and calibration disciplines available through Pittsburgh CMM Calibration and Repair.
What Is Offered
Calibration, repair and programming support for coordinate measuring machines and the gauging used to check their results, coordinated for buyers across Western Pennsylvania and the Upper Ohio Valley.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
CMM Calibration and Repair
Accredited calibration and repair for bridge, gantry and cantilever CMMs and portable arms.
Get a quotation →
CMM Programming
Inspection routine development and revision for bridge, gantry and portable-arm CMMs.
Get a quotation →
Gage Calibration
Calibration of granite surface plates, gauge blocks, and ring and plug gauges.
Get a quotation →
How the Work Is Carried Out
Work is performed under ISO/IEC 17025:2017. Methods, ranges and measurement points are agreed against the request before anything is measured. The certificate or report issued afterwards states the method used, the measurement conditions and the uncertainty that applies.
Coverage across Pittsburgh, PA and the wider Western Pennsylvania and the Upper Ohio Valley area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.