Inspection Programming
CMM Programming
Request a quotation for inspection routine development.
Request a quotation
StandardISO/IEC 17025:2017CoverageWestern Pennsylvania and the Upper Ohio Valley
Routine Development and Revision
Inspection programs are written or revised against the part print and the governing GD&T callouts. Feature selection, probe paths and clearance moves are checked before the routine is released for production use, with stylus configuration matched to the feature being measured.
Existing programs are revised when a print changes, a probe is replaced, or a routine begins returning inconsistent results. Fixturing and part orientation are reviewed alongside the program itself, since a shifted datum scheme invalidates a routine that was otherwise sound.
What a Program Covers
Programs are built around the measurement plan the part requires, not a generic template, with collision and access checked before release.
- 01
Feature extraction
Datums and toleranced features are selected to match the print requirement.
- 02
Path verification
Probe approach and clearance are checked to avoid part or fixture collision.
- 03
Output formatting
Reports are formatted to the layout production or quality requires.
- 04
Program revision
Existing routines are updated when a print, fixture or probe changes.
- 05
Stylus configuration
Probe tip and stylus length are matched to each feature called out on the print.
Development Steps
- 01
Print review
Datums, tolerances and critical features are identified from the drawing.
- 02
Routine build
Probe paths and feature capture are built in the CMM's native software.
- 03
Dry run
The program is run against a known part to confirm clearance and output.
- 04
Handoff
The finished routine and report format are delivered for production use.
Why Pittsburgh CMM Calibration and Repair
- 01
Print-driven builds
Routines are built from the governing drawing, not a generic template.
- 02
Collision checked
Probe paths are dry-run before a program is released for production.
- 03
Revision support
Existing programs are updated when a print or fixture changes.
Coverage across Western Pennsylvania and the Upper Ohio Valley
Service is coordinated across Western Pennsylvania and the Upper Ohio Valley. Availability of on-site versus depot service varies by equipment type and location.
Discuss CMM Programming Requirements
Submit a print to receive a programming quotation.